3 clock divisors, 2 outputs mode, clock type and reset behaviour selected by PCB jumper.
Doepfer's second generation clock divider has been significantly enhanced when compared to the A-160: three sets of clock divisors and two output modes can be selected from and with jupers the reset behaviour and polarity of inputs and output signals can be set. This allows for adjusting the module exactly to your needs.
The upper switch offers two output modes:
-Gate: normal behaviour of a binary divider
-Trig: input pulse width affects output pulse widths
The bottom switch selects one of three clockdivider modes with different divisors:
-power of two: 2, 4, 8, 16, 32, 64, 128
-prime numbers: 2, 3, 5, 7, 11, 13, 17
-integer: 2, 3, 4, 5, 6, 7, 8
Jumpers on the PCB give Clock edge type selected by a jumper on the pc board:
-positive: the rising edge of the clock signal triggers the state change of the outputs
-negative: the falling edge of the clock signal triggers the state change of the outputs
Reset behaviour by two jumpers on the pc board:
-level triggered: the level at the Reset input triggers the Reset
-edge triggered: the edge of the signal at the Reset input triggers the Reset
-positive: a high level (> 2.5V) or the rising edge at the Reset input triggers the Reset
-negative: a low level (< 1 V) or the falling edge at the Reset input triggers the Reset
Output polarity selected by a jumper on the pc board:
-positive: non-inverted outputs
-negative: all seven outputs are inverted
Inputs/outputs
clock input, reset input, eight clock divider outputs
Specifications
4HP wide
Width: 35mm
Current: 50mA