Clean, cool, regulated, and protected power solution for eurorack systems. Recommended for powering up to 104HP (168HP with low-draw module). Requires a power brick or daisy-chain cable to connect to another Row Power module. Simply plug a laptop style power supply into either of the barrel plugs on the 4HP panel. Connect your modules via flying-bus cables, or connect the Row Power to a Distro Board. Bus board is not included and must be ordered separately.
Daisy-chain multiple Row PowerS to use a single power brick for multiple rows. Each row will be independently regulated and protected for ultra-low cross-talk between rows. Rows can also be hot-swapped (plugged/unplugged without powering the whole system down).
*Two power jacks for daisy-chaining multiple Row PowerS: a common laptop-style power brick could power 3-5 rows (typical)
*On/off switch cuts power without interrupting the daisy-chain
*Row Power 30 (white panel) provides more than enough power for a 84HP or 104HP row of modules.
*Ultra-clean: Each rail is separately regulated with high-grade components
*Runs cool: Row Power is efficient so it won't heat up your system. Electronics like to chill!
*Skiff-friendly: only 28mm (1.1") with power connectors installed.
*CV/Gate headers for expansion
*PCB pads for blade tabs for power entry, to be used in custom installations (e.g. if the 4HP panel is not used)
*Row Power 30: +12V @ 1.5A, -12V @ 0.75A, +5V @ 0.5A
*Powered by laptop-style DC power supply (not included): 2.1mm barrel, positive center, 15V-20V.
*A 90W power brick typically powers about 416HP (4 rows of 104HP).
*4HP Wide and 24mm deep (0.96"), up to 28mm (1.1") with power cable